Graco 3A1494D Instrukcja Użytkownika

Repair InstructionsLD Oil Pump Repair Kits3A1494DInstructions for repairing the LD Oil Pump.Maximum Fluid Pressure - 750 psi (5.17 MPa, 51.7 bar)Maxim

Instructions 10 3A1494DNOTE: • The bearing (22) is not included in the kit. This part is reused. The bearing can be installed with either side facing

Instructions3A1494D 11O-Ring Replacement Kit - 24K293 for 3:1 pumps; 24H855 for 5:1 pumps (Fig. 24)NOTE: When replacing seals in the pump lower also s

Instructions 12 3A1494DPump Disassembly,Follow Pump Disassembly instructions Steps 1 - 10 only, pages 3 - 5.Pump Reassembly1. Install o-ring (55) in g

Instructions3A1494D 136. Install new o-ring (5) around air piston (21), Install new o-ring (6) into bottom cover (26). Be sure to apply a thin coat of

All written and visual data contained in this document reflects the latest product information available at the time of publication. Graco reserves th

Warnings 2 3A1494DWarningsThe following warnings are for the setup, use, grounding, maintenance, and repair of this equipment. The exclama-tion point

Instructions3A1494D 3InstructionsAlways use all new parts included in your kit and dis-pose of replaced parts according to all state and local regulat

Instructions 4 3A1494D4. Secure a strap wrench around the fluid cylinder (32) and a large adjustable wrench on the intake valve housing (28). Turn the

Instructions3A1494D 57. Using a 10 mm socket wrench, remove the 5 screws (4) from the flange (29). Using your hand, firmly grasp the end of the displa

Instructions 6 3A1494D12. Check displacement rod (30) for excessive wear or damage. If displacement rod (30) is damaged, replace the pump.13. Using a

Instructions3A1494D 75. Install o-ring (55) in groove on the end of the dis-placement rod (30) (Fig. 12). 6. Push the air piston (21) over the end of

Instructions 8 3A1494D15).12. Perform any air valve repairs / maintenance needed. Instructions for these procedures are included in the separate repai

Instructions3A1494D 9Repair KitsAll Repairs:• Unless otherwise stated, entirely disassemble pump as described in the pump disassembly instruction sect